mixing time
英 [ˈmɪksɪŋ taɪm]
美 [ˈmɪksɪŋ taɪm]
混合时间
双语例句
- Simulation on transport dynamics of hot metal dephosphorization pretreatment by powder injection in torpedo(ⅰ): study on the mixing time and powder-penetration ratio
鱼雷罐喷粉预处理传输动力学物理模拟（Ⅰ）：均混时间和粉剂穿透比研究 - Properties and morphology of thermites mixed up by twin-screw and ball milling procedures are investigated with different mixing time.
采用双螺旋和球磨两种混料方式，研究不同混料时间对（铝）热剂性能及颗粒微现形态的影响。 - This machine has many advantages, such as constant operation, low noise, high loading coefficient and short mixing time etc.
该机还具有运转平稳、噪音低、装载系数高、混合时间短等优点。 - Must mix can be appropriately extended mixing time.
一定要搅拌均匀，可适当延长搅拌时间。 - A Study of Water Modelling on Mixing Time for a 300 t Hot Metal Desulphurization-Pretreated by Double-Lance Injection Process
300t铁水包双枪喷吹脱硫均混时间的水模型研究 - The observed parameters of the experiments are the mixing time and the angle of gas-liquid phase region.
实验考察指标为混匀时间和气液两相区夹角。 - It would be advisable to adjust the mixing time by conducting specific tests.
宜调整时间进行具体的测试。 - The Mixing Time of Exterior Circulative Impinging Stream Reactor
外循环撞击流反应器混和时间实验研究 - The mixing time is adjustable in the panel;
机器运作时间可在面板上调整； - Increase of carrier addition will result in the decreased oxygen transfer efficiency, shortened recycle time, mixing time as well as the decrease of air content.
载体加入量增加，会导致氧传递性能下降，循环时间和混合时间缩短，气含率减小。 - The particle size and moisture content of the powder are affected by lime proportion and mixing time.
等因素影响消化料的粒度组成和水含量。 - Mixer nesting mixing time and the automatic control, to improve the production environment, reducing the labor intensity and improve product quality.
混合机混合时间和排料的自动控制，改善了生产环境，降低了劳动强度，提高了产品质量。 - The utility model has the advantages of gas-liquid contact, long mixing time, sufficient and even mixing, and good mixing effect.
优点是气液接触、混合时间长，混合充分、均匀，搅拌效果好。 - The effects of the core-wall ratio, reaction temperature and mixing time on the release rate of the microcapsules of stabilized chlorine dioxide were studied.
研究芯壁比、反应温度、搅拌时间对微胶囊气体二氧化氯释放速率的影响。 - Through indoor experiments, the influence of sand equivalent changes on the mixing time of micro-surfacing mixture, the emulsifier dosage and the performance after shaped was discussed.
通过室内实验，探讨砂当量变化对微表处混合料拌和时间和乳化沥青用量，以及成型后性能的影响。 - The mixing time of molten steel in the ladle was measured with electrical conductivity method.
以电导法测定了钢包内流体的混合时间； - The interaction of mixing time and filling coefficient was the most effective one.
混合时间与充满系数的交互作用最大。 - The results show that bleeding quality and consolidation strength are a function of mixing time and rotational ratio.
结果表明水泥浆液的泛浆性能和结石体强度是搅拌时间和速率的函数。 - Foamed aluminum with homogeneous structure and high porosity was prepared by using melt-foaming technique, and the influence of the concentration of aluminum powder, foaming agent, mixing time and foaming time on the porosity and pore structure was investigated.
采用熔体发泡法制备了孔结构均匀、孔隙率高的泡沫铝材料，系统研究了铝粉（增粘剂）含量、增粘搅拌时间、保温时间和发泡剂的含量对孔隙率和孔结构的影响。 - The less the viscosity and thickness of the slag are, the shorter is the mixing time.
渣的厚度和粘度越小，均混时间越短。 - In this paper, the random method was used to measure the performance of a shaker mixer and estimate the mixing time, the maximum error of the degree of mixing.
文中采用随机方法测定了摆动式混合机的混合性能，估算了混合时间及混合度的最大误差并与V型混合机作了对比实验； - The impact strength of alloys increased with increasing the mixing time, the blend temperature or rotates speed.
而对于共混物的冲击强度，延长共混时间，在一定范围内增加PcBR含量，降低共混温度或者提高转速，共混物的冲击性能在总体上均呈上升趋势。 - The liquid mixing time is of importance for the agitation process.
液相混合时间是搅拌过程的重要内容。 - Transformation efficiency and cell viability was affected by mixing time.
旋涡振荡对质粒DNA有破坏作用，振荡时间对细胞存活率及转化率都有影响。 - The factors affecting the mixing time and segregating index were analyzed.
分析了影响混合时间和分隔指数的主要因素； - The information on top, bottom and top-bottom mixed blowing with regard to the mixing time are given.
文中给出了有关纯顶吹、纯底吹和顶底复合吹的有关搅拌情况。 - Results showed that the mixing time of 110 s is optimum.
结果表明，拌和时间延长至110s为最佳拌和时间。 - It is showed that the mixing time of the liquid is about 30s;
通过示踪剂考察了反应器的混合特性，液体混合时间在30s左右； - At the same time, the nutrition quality assessment, including mixing speed, mixing time, uniformity.
同时，对营养钵质量进行评定，主要包括混料速度、混料时间、均匀性。 - The influence of mixing time, foaming temperature, foaming-agent dosage and the amount of aluminium powder on the porosity and the pore structure was investigated.
在熔体发泡法制备工艺中，研究了搅拌时间、发泡温度、发泡剂含量、铝粉的加入量对孔结构和孔隙率的影响。